WIFI System have full supportoff all SNMP, SSH and API ready device incl. Mikrotik, Ubiquiti, CISCO etc. FTTx System fully supports all fiber optics SNMP ready device. CATV ISP admin fully supports the internet operation via a cable television distribution. CISCO, ARRIS and Motorola headends are supported. The system provides a simple installation of cable users, complete records of client modems, signal monitoring, headend monitoring and trace amplifiers..... Modems This bookmark enables the administration and monitoring cable modems. There is a survey of modems, the information on modem firmware, the information on set frequencies ... Installation modems ISP admin provides a simple installation of cable users. The modems, which are intended for the installation and are not allocated to particular clients, are entered to the installation modems. These modems boot anywhere in the cable net without problems. However, they are restricted with low speed and the client, who is connected via this modem, comes in for only the administrative interface of ISP admin. In practice an engineer, who carries out the installation, connects the modem in a "restricted mode", then he puts the new client in the administration, sets his parameters and assigns him a cable modem. That is automatically restarted after 5 minutes. After the restart it already boots in a standard mode and it is possible make use of all the services without limitations. Hardware The system ISP Admin automatically downloads current data from all the cable modems, which are online and accessible for the system, via SNMP. This page shows the list of all modems with basic information. Is shows the user´s name, who is connected through the modem, modem MAC address, IP address, the producer, firmware, DOCSIS version which it supports ... If the modem is online, it is possible to click on the modem IP address and thus start ping in the modem. All data is possible to sort out by clicking on the description column in the head of the table. Frequency The list of all modems is shown here with the details concerning the frequency settings, which modems are tuned to. It also gives the name of a user, who is connected through the modem, modem MAC address, backward channel ID, and frequencies of forward and backward channels and ranges of forward and backward channels. If the modem is online, it is possible to click on the modem IP address and thus start ping in the modem. All data is possible to sort out by clicking on the description column in the head of the table. Amplifier When a new user is put in, it is possible to affix him a head end and an amplifier. This amplifier makes for the definition of trace amplifier structure physically placed in the cable net. By amplifiers adjusted you can classify clients in the user list. By clicking on the amplifier name (in the user list) the graphs of SNR modems of all users, who have this amplifier adjusted, will be displayed. If a client registers a SNR decline, the display of all clients in the same amplifier immediately shows whether it is s problem of an individual client, or the problem of the trace amplifier ( SNR fall at all clients ).
